Special Order: 1-3 day lead time
The Edelux II "raises the bar" for dynamo headlights. The beam is wider, more even, and no longer is there a dark near field area (directly in front of the bike).
The beam is asymmetric (like an automotive low beam) and concentrates the light on the road where it is needed most. Glare for oncoming riders and drivers is reduced. For added safety, a stand light glows for several minutes when the rider stops. There is no Senso mode as on the original right side up (non-inverted) model.
The Upside Down (inverted) Edelux II is available in two versions. One has a two position switch (on/off) and a 140 cm wire with bare ends. The second model has no switch and is designed to be used with an external switch or run "always on" if wired directly. Rather than hard wired leads, it has connectors for wires running to it from the switch or dynamo.
The glass lens has a non-glare coating for maximum efficiency and durability. The housing is completely sealed against moisture.
We include loose 4.8mm spade connectors (for Schmidt hubs) at no charge or install them at a specified length for $12 (make a note in the comment field at checkout for this service).
|Switched w/140cm wire.. (1-3 day lead time)||SCH680001||LT1484|
|Unswitched w/connectors (1-3 day lead time)||SCH680000||LT14841|