Note: Stems with a 1" diameter quill fit 1-1/8"(O.D.) forks. Made of cro-moly steel. A stem raiser fits into the steering column in place of your present stem, and secures with a wedge bolt in the normal manner. The upper part of the stem raiser sticks out above the steerer, and is bulged out so that you can insert your original stem. The bottom of the original stem winds up a bit above the top of the headset, so you gain several inches of height. This size fits bikes with "oversized" stems. Actual outside diameter of the riser is 1" (25.4) mm. This size was used on some mountain bikes from the 1990s and early 2000s, but it is not as common as the 1 1/8" threadless type used on most newere bikes. Note, you may need to install longer brake and/or shift cables. You'll need a long 6mm allen wrench to tighten the bolt in the stem riser.
These shims let you use a standard 25.4 mm (1 inch) diameter handlebar in an Italian size (26.0 mm) stem. Note: These shims make for a very tight fit. Sometimes only one shim is needed.
Page 1 of 1