Filter By:

Headlight

Schmidt Schmidt Edelux II Generator Headlight
$188.00
The new Edelux II "raises the bar" for dynamo headlights. The beam is wider, more even, and no longer is there a dark near field area (directly in front of the bike). The beam is asymmetric (like an automotive low beam) and concentrates the light on the road where it is needed most. Glare for oncoming riders and drivers is reduced. For added safety, a stand light glows for several minutes when the rider stops. The Edelux II has a three position switch (on/senso/off). In senso mode it will automatically come on in low light (like a tunnel or deep shadows) for safety. The glass lens has a non-glare coating for maximum efficiency and durability. The housing is completely sealed against moisture. Comes with necessary wiring for headlight only. Taillight wiring not included. See Related Items. Features include: -90 lux output - SUPER BRIGHT! -Standlight -On/Off and Senso mode (3 position switch) -Can be used with, or without, a tail light. -Aluminium casing and copper heat sink for efficient dissipation of heat from the LED. -Available in black anodized, silver anodized, polished aluminium, or red anodized. -Weight: 85g.
Schmidt Schmidt Upside Down Edelux II Generator Headlight
$201.00 - $216.00
Special Order: 1-3 day lead time The Edelux II "raises the bar" for dynamo headlights. The beam is wider, more even, and no longer is there a dark near field area (directly in front of the bike). The beam is asymmetric (like an automotive low beam) and concentrates the light on the road where it is needed most. Glare for oncoming riders and drivers is reduced. For added safety, a stand light glows for several minutes when the rider stops. There is no Senso mode as on the original right side up (non-inverted) model. The Upside Down (inverted) Edelux II is available in two versions. One has a two position switch (on/off) and a 140 cm wire with bare ends. The second model has no switch and is designed to be used with an external switch or run "always on" if wired directly. Rather than hard wired leads, it has connectors for wires running to it from the switch or dynamo. The glass lens has a non-glare coating for maximum efficiency and durability. The housing is completely sealed against moisture. We include loose 4.8mm spade connectors (for Schmidt hubs) at no charge or install them at a specified length for $12 (make a note in the comment field at checkout for this service). Features include:
  • 90 lux output - SUPER BRIGHT!
  • Standlight
  • Can be used with, or without, a tail light.
  • Aluminium casing and copper heat sink for efficient dissipation of heat from the LED.
  • Available in polished silver finish only.
  • Weight: 85g.
  • Page 1 of 1